AVID UTV - Can-Am Maverick R / R MAX Front Upper Control Arm Inner Pivot Gusset Kit

The AVID Racing Can-Am Maverick R Upper Control Arm Inner Pivot Gusset Kit is built to reinforce the upper A-arm inner mounts and tie them into the chassis for race-level strength. This weld-on kit is laser cut from 3/16 inch 4130 chromoly plate and uses machined weld washers that pierce through the factory pivot brackets. The control arm bolt runs through a true half-inch thick machined hole for maximum support and durability at the inner pivots.

• Strengthens upper arm pivots: Machined weld washers pass through factory inner mounts and create a solid, half-inch thick machined bore for the control arm bolt.
• Mechanically ties into the chassis: Gusset plates and weld washers attach the upper arm mounts to the surrounding frame, reducing flex and spreading load through the front structure.
• Built for hard use: Ideal for long travel kits, race uprights, and aggressive desert or short course driving where factory A-arm pivots are pushed to the limit.
• Clean weld-in design: Parts locate off stock mounts for straightforward installation by a qualified fabricator.

• Direct fit upper control arm inner pivot gusset kit for Can-Am Maverick R
• Weld-on design fabricated from 3/16 inch 4130 chromoly plate
• AVID machined weld washers pierce factory mounts and create a half-inch thick machined control arm bolt bore
• Mechanically ties upper arm pivots into the chassis for added rigidity and support
• Designed to complement AVID Maverick R front suspension and race upright packages

• Left and right 3/16 inch 4130 chromoly upper control arm inner pivot gusset plates
• AVID machined weld washers for upper A-arm inner pivot locations
• Installation notes for fitment and welding locations

Installation: This kit is weld-on and should be installed by a qualified fabricator or chassis shop. All paint or coating must be removed from weld areas before installation.