L&W Fab - Polaris RZR 1K / Turbo Factory Style Tie Rods

Factory Style Ball and Socket Tie Rods

This listing is for a set of tie rods made from 6061 aluminum and manufactured in America. Each set comes with spindle ends, so no separate purchase is needed unless you require a replacement spindle end.

Sizing Information

To determine whether you need M14 or M16, measure the ends of your factory tie rods where they screw into the rack. If the end is less than 1/2?, you need M14. If it is over 1/2?, you need M16. Turbo models typically use M16 (measurement recommended). The 1000 model varies and requires measurement. 2016 Turbo models always use M14.

Available Options

• M14x1.5 rack side by M14x1.5 tie rod side. 5-5/8? total length (4? from rack to end of jam nut)
• M16x1.5 rack side by M14x1.5 tie rod side. 5-5/8? total length (4? from rack to end of jam nut)

HD Rebuild-able Tie Rod Ends

Fully rebuildable ends come assembled with grease and ready for installation. Compatible with L&W tie rods and many others. Made from heat-treated 4140 steel with black oxide finish. 100% made in USA with an 18-month warranty.

Factory ends are not warrantied; only the tie rod itself is covered.