Skip to main content
Shipping from 12 warehouses nationwide

International Shipping

  • Finland
  • France
  • Gabon
  • United Arab Emirates
  • United Kingdom
  • Puerto Rico
  • Peru
760 746 0600

(Mon - Fri 8:00 am - 5:00 pm PST)

Evolution Powersports - CFMoto ZFORCE Z10 ECU Bench Power Flash

(No reviews yet) Write a Review
$495.00
MSRP: $600.00
You save - $105.00 (17.50%)
item#:
EVO-1002040002

EVP ECU Power Flash for 2026 CFMOTO Z10

EVP's tuning development for the Z10 focuses on building strength across the entire power band—harder acceleration, sustained power throughout the pull, cooler engine temperatures for consistent performance, and power carried through the usable RPM range for improved overall drivability.

ECU Flash Stage Fuel (Octane) Wheel HP Crank HP
Stock 91 128 154
Stage 1 91 144 173
Stage 3 w/ Fuel Pressure Regulator 91 161 192

Stage 1: +16 WHP gain utilizing the stock fuel system—an 11.5% increase without fuel-system modifications.

Stage 3: +33 WHP gain with the required included Fuel Pressure Regulator—a 25% increase in wheel horsepower over stock.

Stage 1 carries approximately 140+ wheel horsepower across a broad portion of the pull, where stock calibration sits at 105–115 WHP. The gains live in the middle of every run, not just at peak.

Stage 3 raises the entire upper portion of the curve, holding approximately 150–160 WHP through most of the usable speed range. This adds another 17 WHP over Stage 1—an additional 12%—while maintaining a broad, usable power curve.

EVP optimized the Z10's factory cooling system through ECU calibration to improve airflow through the intercooler and radiator without additional hardware.

Cooling Benefits:

  • More consistent power throughout a run
  • Increased airflow through the intercooler and radiator
  • Better control of intake-air and coolant temperatures
  • Reduced temperature-related ignition timing retard
  • Improved knock resistance when running pump fuel
  • Better performance during demanding low-speed and high-load operation

All factory high-temperature fan operation is retained. If coolant temperature reaches factory-programmed thresholds, both fans can still operate at up to 100% duty cycle as required.

Dyno gains translate to measurable acceleration improvements. Stage 1 is only 0.10 second ahead at 30 mph, but by 50 mph it's 0.91 second ahead, and by 60 mph it's 1.41 seconds ahead. Stage 3 reaches 60 mph 0.24 seconds quicker than Stage 1 and uses 23.56 fewer feet—even with density altitude roughly 760 feet higher.

  • EVP Stage 1: +16 WHP gain utilizing the stock fuel system
  • EVP Stage 3: +33 WHP gain with required/included Fuel Pressure Regulator
  • Revised fan-on temperatures keep engine cooling and performance optimized
  • OEM speed and rev limiters raised
  • Torque limits raised for harder pulls and better throttle response
  • Front differential lock speed/power limitation removed
  • Smooth, broad power curve with horsepower gains carried throughout
  • EVP Stage 3-91 tuning software and the required Fuel Pressure Regulator are not compatible with Stage 1-91 software.
  • All EVP Z10 tuning requires OEM exhaust and is not compatible with any aftermarket exhaust systems.
  • Draggy times for Stage 1 and Stage 3 tunes were obtained with EVP Clutching (coming soon).
  • All dyno runs were performed in EVP's Wisconsin R&D center. Performance may vary based on atmospheric conditions and/or altitudes.

2026 CFMOTO Z10

This tuning product is intended for off-road and competition use only unless otherwise stated. Installation and use may affect emissions compliance, vehicle performance, durability, and warranty coverage. Buyer is responsible for verifying fitment, intended use, and compliance with all applicable local, state, and federal laws before installation or operation.



Fits The Following Vehicles

  • 2026 ZFORCE Z10