AVID UTV - Can-Am Maverick R / R MAX Billet Aluminum Front Suspension Kit

The Can-Am Maverick R Billet Front Suspension Kit from AVID Racing is engineered for hard use and easy maintenance. It combines proven Baja front suspension geometry with one-piece 7075-T6 billet aluminum control arms, five-axis machining, and replaceable stainless steel service points throughout. The complete kit includes upper arm, lower arm, and billet upright assemblies with all hardware and bearings.

The Baja design optimizes the entire suspension cycle by addressing king pin inclination, caster, scrub radius, camber gain, Ackermann, and bump steer together. Geometry is designed around a zero-offset wheel and 35-inch tire for predictable tracking at speed, direct steering response, and consistent tire performance through corners and suspension travel.

• 10-degree king pin inclination
• 7-degree caster
• Positive 1-inch scrub radius
• 0.5-degree camber gain from full droop to ride height, progressing to 3.5 degrees at full bump
• Controlled Ackermann and less than 1/4-inch bump steer on 35-inch tires

Each control arm is machined from a single piece of 7075-T6 billet aluminum on a five-axis machine. Every pivot uses a replaceable 17-4 stainless steel bolt-in cup, and every bolt-through location uses a replaceable 17-4 stainless steel press insert. Worn service components can be replaced individually without replacing the entire arm.

The 7075-T6 billet uprights feature vertical 1-inch uniballs in true double shear, with 7/8-inch uniballs or rod ends at the chassis and tie rod pivots.

The lower control arm features an opening large enough for the axle and CV joint to pass through. Removing the lower knuckle bolt provides access to pull the axle from behind the knuckle and through the arm, allowing axle swaps with the control arm and shock remaining installed.

• Complete billet upper control arm kit
• Complete billet lower control arm kit
• Complete 7075-T6 billet upright kit
• All hardware
• All bearings

This suspension design requires tie rods approximately 3/8 inch shorter than factory setup. Confirm that your tie rods have enough adjustment for the required length.