Skip to main content
Shipping from 12 warehouses nationwide

International Shipping

  • Finland
  • France
  • Gabon
  • United Arab Emirates
  • United Kingdom
  • Puerto Rico
  • Peru
760 746 0600

(Mon - Fri 8:00 am - 5:00 pm PST)

AGM Products - UTV Uni-Ball Tool

(No reviews yet) Write a Review
$227.69
MSRP: $275.99
You save - $48.30 (17.50%)
item#:
AGM-AGM-UBT-0875

The AGM Uni-Ball Tool lets you replace worn uni-balls, also known as spherical bearings, without removing the suspension or steering component from the vehicle.

Instead of pulling large components off the car, fighting them in a shop press, or beating on expensive parts with a hammer and punch, the Uni-Ball Tool gives you a compact, controlled way to press the worn bearing out and install the new one.

After removing the retaining C-clip, the tool uses a piston, cup, ACME-thread bolt, load-bearing washer, and nut to pull the worn uni-ball out of the component and into the receiving cup. To install the new uni-ball, flip the cup and piston positions and press the replacement bearing back into place.

Built for race teams, fabricators, repair shops, and serious DIYers, each Uni-Ball Tool is made from high-strength steel for repeated service in the shop, garage, or alongside the race course.

  • 7/8 in. Uni-Ball Tool — Size 14 spherical bearings
  • 1 in. Uni-Ball Tool — Size 16 spherical bearings
  • 1-1/4 in. Uni-Ball Tool — Size 20 spherical bearings
  • 1-1/2 in. Uni-Ball Tool — Size 24 spherical bearings
  • Press cup
  • Press piston
  • ACME-thread bolt
  • Load-bearing washer
  • Nut
  • Cup and piston: Black oxide coated steel
  • ACME-thread bolt and nut: Zinc coated steel

Use hand tools only. Do not use an impact wrench or powered driver to operate the Uni-Ball Tool.