UTV Stereo Polaris RZR Ride Command Amplifier Harness - Turn On & Delay Regulated
You need this part because it regulates the voltage on the blue remote out wire to fix these common Ride Command Problems. Simply plug into AMP1, AMP2, or AMP3 then connect RCAs and Remote to your amplifier, its that easy.
Factory Plug AMP1: (they are labeled) is the front output, full range. Controlled by “front” on Ride Command
Factory Plug AMP2: (they are labeled) is the rear output, full range. Controlled by “rear” on Ride Command. Tip For Installs where you are installing a sub woofer but do not have a sub control knob and you do not need a front to rear fader for the highs, you can use the rear output as a sub channel. Then by fading front to rear you have some control over the level of the sub woofer. So fading to front produces less sub output, and fading to rear produces more sub output by lowering fronts.
Factory Plug AMP3: (they are labeled) full range output. Not independently controlled by Ride Command, no on screen adjustments. This is a good option for sub woofer.
Note:
- Not Compatible with M-Series or Signature Series Amplifiers
- Works on 2 and 4 seat Models
